#Need username and password for n300 manual
#Need username and password for n300 upgrade

#Need username and password for n300 upgrade

If want to upgrade it later, please contact with our service team. This device is using 2020 newest firmware and no need to upgrade. The temperature of this device during operation is within a reasonable range, please rest assured to use. After set to AP mode and then need to change settingĪll electronic devices will have different degrees of normal heating during use.If you meet below issues, please reset the device: Keep it away from Bluetooth, microwave, fridge and heavy walls, etc.Put it in a signal strong area between your home router and target room.What’s the best location to place the WiFi Repeater? If AP Mode, please check with your network provider. If Repeater Mode, please check Step 6, you might enter a wrong password. Please proceed the setup steps.Īfter setup done, why no internet connection? It’s correct, because you haven’t set it up. Please manually open the browser and type 192.168.10.1 in address bar to open admin page.īefore setup, why Wireless-N-c shows No internet con-nection? What if the admin page doesn’t open automatically after connected to Wireless-N-c? If manually setup, the IP address was wrongly input.After setting AP mode, the IP address cannot be entered again.Not connect with the network Wireless-N-c.Long press the reset button for about 20 seconds till the Wireless-N-c signal becomes open and unsecured. (AP Mode needs to connect to an Ethernet cable to your home modem.) When you have an existing wifi router/mo dem and your router/modem has been dialed, you can select AP mode to create a wireless access point.(Repeater mode doesn’t need to connect Ethernet cable) When you have an existing wifi but the wifi range is not long enough, please select Repeater Mode to cover longer range and eliminate wifi dead zones.

Set a wifi name and wifi password for the wireless access point.Ĭon6nect your home modem with this wifi extender via its LAN port ( LAN port to your home modem, LAN LED: On or Blinking) Step 1~3, Power On and Enter into admin Page. Open wifi list and search the new wifi extender’s signal, input password to access into internet. (You can set a new wifi password for the wifi extender, or keep same wifi password as main wifi signal)Ĭlose the browser. (Optional) You can change or not change the wifi extender’s WiFi name and password.

Please correctly input your extend-needed wifi’s password, the wifi signal that you selected in step 5.

#Need username and password for n300 manual

(If you want to extend a hidden network, please click Manual Setup and manually input your hidden wifi information). Please select the wifi signal that you want to extend. The wifi extender will scan available wifi signals automatically. (If using computer, please manually open a browser and type 192.168.10.1 in address bar to enter into admin page) ( If not opened, please manually open a browser and type the IP address 192.168.10.1 in address bar to enter into admin page. 2 Search the wifi signal named “ Wireless-N-c” and connect to it on phone.Īfter connected to Wireless-N-c, phone will open the admin page automatically.